Blog Introduction: Looking for a way to connect your HyperX earbuds to your iPhone 8? You’ve come to the right place! Here, we’ll walk you through the process step-by-step. We’ll also provide some helpful tips and tricks along the way so that you can get the most out of your HyperX earbuds while they’re hooked up to your iPhone 8. Let’s get started! 

Step 1:

Make sure both devices are powered on. Before anything else, make sure your HyperX earbuds and your iPhone 8 are both turned on and functioning properly. If either device is turned off or in sleep mode, then the connection process won’t work. 

Step 2:

Locate Bluetooth menu on the iPhone 8. On your device’s home screen, swipe up from the bottom of the display to open up the Control Center. From there, tap on the Bluetooth icon (which looks like a “B” surrounded by waves) and make sure that it is set to “On.” This will allow other devices within range—like your HyperX earbuds—to detect it and establish a connection with it.  

Step 3:

Activate pairing mode on your HyperX earbuds. Now that Bluetooth is enabled on your iPhone 8, you need to activate pairing mode on your HyperX earbuds so that they can connect with it. To do this, press and hold down both volume buttons simultaneously until you hear a beep sound (this usually takes about 5 seconds). Once you hear this sound, release both buttons and wait for a few moments until you see “Connected” appear in small letters beneath the Bluetooth logo in Control Center. 

Step 4:

Enjoy! Now that both devices have been connected successfully, all that’s left to do is enjoy! Your music should now be playing through your HyperX earbuds with crystal clear sound quality thanks to their advanced audio drivers and noise cancellation technology. And if you ever want to disconnect them from your phone again, just repeat steps 1-3 but in reverse order—i.e., deactivate pairing mode on your headphones first before disabling Bluetooth on your device afterwards. 


Connecting HyperX earbuds to an iPhone 8 is easy as pie when you know what steps to take! All it takes is a few minutes of setup time and then you’ll be ready to enjoy crystal-clear sound quality without any hassles or headaches involved at all. And don’t forget—if ever want disconnect from each other in future, just follow these same steps but in reverse order! As long as both devices are powered on during this process, everything should work just fine every single time!


Leave a Comment